Network Plot Explained: How to Make, Read and Report It

By Dr. Faheem Afzal Shah, Founder, StatFAS.com · Tool: Network Plot Generator

A network plot draws a network: nodes as points and edges as lines. Its purpose is to make structure visible, such as clusters, hubs and isolated nodes. It complements, but does not replace, numerical network metrics (see the network analysis guide).

How layouts work

Most network plots use a force-directed layout, in which connected nodes attract and all nodes repel (Fruchterman & Reingold, 1991). Positions are therefore a visual convenience: two plots of the same network can look different. Distance on the page is not a statistical quantity unless the layout is explicitly constrained to be one.

Original example (illustrative)

Four variables A–D with the following correlations: A–B .52, A–C .41, A–D .12, B–C .35, B–D .28, C–D .47. Drawing an edge when |r| ≥ .30 keeps A–B, A–C, B–C and C–D: 4 of the 6 possible edges, so density = 4/6 = .67. Degrees are A = 2, B = 2, C = 3, D = 1 (sum 8 = 2 × 4). Node size by degree makes C the largest, and edge thickness by |r| makes A–B the thickest line.

With a threshold of |r| ≥ .40, only A–B, A–C and C–D survive and B has degree 1. The threshold is a researcher decision that changes the picture, so justify and report it, preferably with a sensitivity check. Plots of thresholded correlations also display pairwise associations rather than direct effects.

How to make it in StatFAS

Open the Network Plot Generator.

Reading and reporting

Identify hubs (high degree), bridges, communities and isolates, and cross-check with numbers from the network analysis calculator. Caption: Figure 1. Network of four variables; edges show |r| ≥ .30; node size = degree; edge width = |r|.

Common mistakes and alternatives

Reading page distance as similarity, hairball plots with too many edges, unexplained thresholds, no legend for node and edge encodings, and colour used without a stated meaning. Alternatives: adjacency matrix heatmaps, the chord diagram for flows, and tables of centrality indices.

Conclusion

A network plot is a communication aid: state how nodes, edges and layout were defined, and support visual impressions with metrics.

Screenshots to supply (genuine captures only):
1. statfas-network-plot-interface.png, alt: "StatFAS Network Plot Generator interface"
2. statfas-network-plot-example-data.png, alt: "Example data entered in the StatFAS Network Plot Generator"
3. statfas-network-plot-settings.png, alt: "Network Plot Generator settings in StatFAS"
4. statfas-network-plot-result.png, alt: "Network Plot Generator result generated in StatFAS"

References